Category: Subdivision

• The below table specifies the minimum required lot sizes and frontages in particular areas of the Moreton Bay Region
• Where no minimum lot size or frontage is specified, generally the density of the development is used to determine the number of lots potentially created
• Where the subdivision specifics in the below table cannot be met, compliance with the applicable performance outcomes of the code must be demonstrated
• It is important to note that the planning scheme does not support subdivision in the following areas:
  • Limited development zone
  • Emerging community zone – Interim precinct
  • Emerging community zone – Transition precinct (creating developable lots)
  • Caboolture West local plan where no Neighbourhood development plan is approved by Council and included in the Local plan
  • Redcliffe Kippa-Ring Local Plan Interim residential precinct
• Where a property is already meets the minimum lot size or density in the below table, further subdivision of the property is unlikely to be supported.
• If your property is affected by an environmental overlay, additional requirements may apply which may restrict the ability to subdivide the property.
• You can find your property zoning and any identified overlays through the Council website or by contacting Urban Planners Queensland

NOTE: The below information should be used as a guide only and does not replace site specific town planning advice.